Previous Repair
Motor Check - 23-02-07
Time to see what's inside the motor ! it was easyer to unmount than advertized elsewhere. Just follow pictre to get an insight on. I won't cover step by step remove, but the overall operation in no particular order, maybe i'll write some more detailed information later 
contact me.
This is the motor at it's basic: the armature, the endcap and the rotor. 
That's the end of the roto with two rings, one flat and one ondulated to keep the rotor in place 
Bottom of the motor view 
This is the cap with the two brushes, they are still long 
The rotor again... the assembly of the wres is one time only, no further unmount 
The armature, notice the ferromagnets inside the transparent plastic, a lot of powder inside ! 
General dirt 
Closeup view 
The surface is not perfect, some rust inside but nothing of serious 
Washed ! that's a better shot ! 
Some minor surface to clean out, no moving parts here 
That's curious, why that thing inside ? below the explanation 
Notice the sign to fit it back in place, however if you won't put it right, it won' close 
Armature sign for the endcap mount 
Close the 2 long screw and you are done 
This is how to keep the brushes out, GENTLY put a small screwer and pull out the copper wire. 
Don't pull too much, applyng the screwremover like this is sufficient to retract enought the brushes 
another shoot 
Small details 
Back to c5 blog
Back to C5 main
Public file repository 
Back Home